Golf clubs have lots of options for customization. For instance, you can change golf club grips[how to change golf club grips] to make it more comfortable. Meanwhile, bending golf club lie angle at home[how to bend golf clubs lie angle at home] is possible to maximize its performance. Another thing that you can do is to change the golf club head to restore its peak appearance and optimize power in every shot.
Luckily, changing the head of a golf club does not have to be difficult nor expensive. With little time and effort to spare, it can be a quick DIY task. Read on and we’ll share some tips to do it right.
Table of Contents
How to Change Golf Club Heads
From the top Callaway irons to the best TaylorMade drivers, it isn’t easy letting go of old golf clubs. It is a waste of money if you will throw one when it can still be saved. In many instances, you can restore its original condition and make it even better by replacing the club head. Here’s a quick step-by-step guide on how you can do so.
Position the Golf Club
The best way to do this task is to have a vise, which will clamp the golf club and make it more stable as you work. While you can hold it with one hand while the other hand does the job, it can be tricky. It is easier when it is set on a flat position.
Heat the Club Head
You will need a torch to heat the hosel. This will make it easier to remove later. Do not be afraid to do so. Especially if your club has high quality, applying heat will not damage its construction. Nonetheless, make sure to control the heat that you are applying. Use a hand-held torch to heat the hosel for at least 30 seconds.
Pull the Club Head
After heating the hosel, you are now ready for taking the club head off. Wear gloves because it will be hot. Grab the head, twist, and pull. It will not easily go off at first, so you need to exert effort rotating before finally pulling. The club should be secured in the vise to keep it stable. If you cannot remove the head, heat for 15 more seconds and try again.
Clean the Tip
With the head now out of the shaft, clean the hosel or the tip of the club. Wipe it with a clean cloth. You can also use mild soap and water. This is important to get rid of any debris on the surface, which will also make sure that the head will be secure in place.
Apply Glue
Next, apply glue on the end of the shaft. You can use any glue, but the ones that work best are those that are thin. The stronger the glue, the more durable the attachment will be, especially if you swing aggressively.
Attach the Club Head
With the glue now on the surface, you are ready to attach the club head. Insert it on the end of the shaft. Twist and turn until you lock it in place. Wipe the excess glue off the shaft. Let it dry. Using the golf club before it dries will result in a weak attachment.
Conclusion
Restore the look and performance of your golf club while changing its head. It can be prone to dirt, rust, and other problems over time, so a replacement can be beneficial. As noted above, it is as simple as putting the club on a vise, heating the hosel, pulling the head, applying glue, and replacing the head.